Volvo XC90 TWIN ENGINE 2019 Owner's Manual page 532

STARTING AND DRIVING
||
call 00 8000 466 354 65 (or the toll number
+49 6838 907 277) 23 .
Reprogramming individual buttons
To reprogram an individual HomeLink
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2. Once the indicator lamp on HomeLink
starts to flash slowly, programming can
continue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved program-
ming.
Resetting the HomeLink
It is only possible to reset all of the HomeLink
buttons at the same time, not each button
individually. Individual buttons can only be
reprogrammed.
Press and hold depressed the outer but-
–
tons (1 and 3) on HomeLink
10 seconds.
> When the indicator lamp changes over
from a constant glow to starting to
flash, the buttons are reset and ready to
be reprogrammed.
23 Note that the toll-free number may not be available depending on operator.
24 Applies to certain markets.
530
Related information
• Using HomeLink
• HomeLink
®
button, • Type approval for HomeLink
®
®
buttons
®
®
for approx.
®
* (p. 530)
®
* (p. 528)
®
* (p. 531)
®
24
Using HomeLink
*
®
When HomeLink is fully programmed it can
be used in place of the separate original
remote controls.
Depress the programmed button. The garage
door, gate, alarm system or similar is activated
(may take a few seconds). If the button is
depressed for more than 20 seconds then the
reprogramming is started. The indicator lamp
illuminates or flashes when the button has
been depressed. Naturally the original remote
controls can still be used in parallel with
®
HomeLink if required.
NOTE
When the ignition has been switched off,
®
HomeLink works for at least 7 minutes.
NOTE
®
HomeLink cannot be used if the car is
locked and the alarm is armed* from the
outside.
* Option/accessory.