Table of Contents
Advertisement
13. Control Assembly Removal
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Remove the screws holding the hood exhaust
louver to oven cavity front face plate.
5. Remove the hood exhaust louver from the oven by
pushing the left tabs of the hood exhaust louver.
6. Remove the screw holding the control panel to
the oven cavity front face plate.
7. Release the control panel from the oven cavity front
face plate by lifting it up.
8. Disconnect the wire leads from the relays.
9. Disconnect the connectors from the control unit.
10. Remove the control assembly from the oven.
11. Now, the control assembly is free.
12. Remove the screws holding the PCB to the control
panel.
13. The PCB is now free.
14. Stirrer Motor Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Remove the screw holding the lamp cover to the
oven cavity front flange, then remove the lamp cover.
5. Disconnect the wire lead from the stirrer motor.
6. Remove the screws holding the stirrer motor to the
cavity.
7. Now, the stirrer motor is free.
1 5 . Stirrer Bracket and Stirrer Fan Removal
1. Disconnect the power supplier cord.
2. Open the door and block it open.
3. Remove the plastic nail with '一' driver.
4. Counterclockwise rotate the stirrer bracket.
5. Now the stirrer bracket and stirrer fan is free.
16. Door Assembly Removal
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor.
4. Remove the screws holding the hood exhaust
louver to the oven cavity front face plate.
5. Remove the hood exhaust louver from the oven
cavity by pushing the right and left tabs of the hood
exhaust louver.
6. Disconnect wire lead from the top left corner of cavity.
7. Lift up the door assembly to release the upper and
lower door hinge pins from the upper and lower
oven hinges. Door assembly is now free.
1 7 . Sensor Humidity Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Remove the screw holding the control panel to the
oven cavity front plate.
5. Push up the control panel and remove it from cavity
and hold it at the front plate by the control panel flange.
6. Disconnect the wire leads from the control panel.
7. Remove the screw holding the hood motor to cavity
and remove the hood motor.
8. Remove thescrews from the air duct to cavity.
9. Remove the screw from the air grid *R to cavity and
remove the air grid *R.
10. Remove the screws from the air duct to fan guide.
11. Remove the screws from the air duct to back wind
guide.
12. Remove the screw from power cord to back wind guide.
13. Remove the screw from earth connection of noise
filter to cavity.
14. Disconnect the wire leads from the air duct assembly.
15. Now, the air duct assembly is free.
16. Remove the screws from sensor humidity to air duct.
17. Now, the sensor humidity is free.
7
Advertisement
Table of Contents
