Component Teardown; Hood Ehaust Louver Removal; Removal Of Oven From Wall; Outer Case Removal - Midea EM048K6DMP Service Manual

CAUTION
1. Disconnect oven from power supply before
removing outer case.
2. Discharge the high voltage capacitor before
touching any oven components or wiring.
NOTE
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of the
high-voltage capacitor (that is the connecting lead of
the high-voltage diode) against the chassis with the
use of an insulated screwdriver.
1. Hood Exhaust Louver Removal
Remove the oven from the wall and proceed as follows:
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60sec.
4. Remove the screws on the top holding the hood
exhaust louver to the oven cavity front face plate.
5. Pull the hood exhaust louver from the oven cavity by
pushing the left tab of the hood exhaust
louver to remove.
6. Now, the hood exhaust louver is free.
Tab (left )
Push

COMPONENT TEARDOWN

Hood Exhaust
Louver
Push

2. Removal Of Oven From Wall

NOTE
Two persons are recommended to remove the oven
from a wall installation.
1. Disconnect the power supply cord, and uncoil the
power supply cord.
2. To discharge the high voltage capacitor, wait for 60sec.
3. Remove the turntable tray and support from the oven
cavity.
4. Remove the three (3) screws holding the oven
(outer case cabinet) to the top cabinet.
5. While supporting the front of the oven, and release
the oven from the unit mounting plate.
6. Pull the power cord out of the wall cabinet and
remove the oven.
7. The oven is now free and can be placed on the work
surface selected for servicing the oven.
8. Installation is the reverse of this procedure.

3. Outer Case Removal

Remove the oven from the wall and proceed as follows:
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60sec.
4. Remove screws holding the top stay to the hood fan
motor or the oven, and remove it.
5. Remove the seven (7) screws from the rear of the
outer case cabinet and two (2) screws at right,and
five (5) screws at top,and four (4) screws at bottom.
6. Slide the outer case cabinet back to free it from
retaining clips on the cavity face plate.
7. Now, the outer case is free.
4