Table of Contents
Advertisement
8 8 8 8 8 8 8 8 8 8 8 8 . Hood Fan Motor Removal
8
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the 6-pin connector of the hood fan
motor from the main wire harness located at the
right edge of the hood duct and release the snap
band from the hood duct. Remove one (1) screw
holding the Hood fan motor on the rear cavity.
5. Remove hood fan motor from the oven cavity top
plate by lifting it up. Hood fan motor is now free.
9 9 9 9 . Thermal Cut-Out (Cavity) Removal
9
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the wire leads from the thermal cut-out
(cavity).
5. Remove the thermal cut-out (cavity) from the holder
at the air duct.
10. 8 8 8 C ooling Fan Motor Removal
1. Disconnect the power supply cord, remove oven
from wall, then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the wire leads from the fan motor.
5. Remove the one (1) screws holding the fan guide
to back wind guide.
6. Push up the fan guide and remove it from back
wind guide.
7. Remove two (2) screws holding the fan motor to fan
guide.
8. Remove the fan motor from the fan guide and the fan
blade by pulling the fan motor with your hand. The
fan blade will fall as the motor is removed.
11. T
urntable Motor And
Sockets Removal
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove the screws holding the bottom guide plate
to the oven cavity front face plate.
4. Remove the screws holding the base plate to the
bottom of cavity and outer case.
5. The base plate is now hanging on the rear cavity.
TURNTABLE MOTOR
6. Disconnect the wire leads from the turntable motor.
7. Remove the screw holding turntable motor to the
oven cavity.
8. The turntable motor is now free.
HOOD LAMP SOCKET
9. Disconnect the wire leads from the lamp socket.
10.
Remove the two lamp covers and remove the screws
holding the lamp socket to the base plate. Remove
the lamps. The lamp socket is now free.
12. Oven Lamp And Lamp Socket Removal
1. Disconnect the power supply cord, remove the hood
exhaust louver.
2. Remove the screws holding the lamp cover to the oven
cavity front flange, then remove the lamp cover.
3. Disconnect the wire leads from lamp socket.
4. Turn the oven lamp out from the lamp socket.
5. Turn the hooks of lamp socket bracket and release the
lamp socket.
6
H
ood Lamp
Advertisement
Table of Contents
