Table of Contents
Advertisement
Instructions for use MULTIflex LED coupling 460 LED - 1.007.3201
6 Checking for malfunctions and troubleshooting | 6.1 Checking for malfunctions before initial start-up
6 Checking for malfunctions and troubleshooting
6.1 Checking for malfunctions before initial start-up
Danger from hot lamp.
Risk of burn injury.
4 Do not touch lamp after previous operation. Allow the lamp to cool down.
Missing or damaged O-rings.
Malfunction and premature failure.
4 Make sure that all O-rings are on the coupling and are undamaged.
NOTE
Stop working if the O-ring is missing or damaged.
4 If there is no O-ring on the motor coupling, replace the O-ring.
4 If the intensity of the KaVo MULTI LED lamp is low, increase the cold light
intensity on the unit.
4 If the KaVo MULTI LED lamp glows red or not at all, turn the KaVo
MULTI LED lamp by 180° and insert it.
Also refer to:
6.2.1 Replacing the LED lamp, Page 16
6.2 Troubleshooting
Repair WITHOUT using KaVo original spare parts.
Parts such as the cover can come loose and cause injury. Aspiration, swallowing
of parts and danger of suffocation.
4 Only use spare parts that comply with the specification for repair; original
KaVo spare parts comply with the specification.
NOTE
If a repair is done with NON-KaVo original spare parts, this may constitute a
product modification that leads to the loss of CE conformity. In the event of
damage, the responsibility is with the service company or the operator.
The introduction of a modified product in the market, in which the reasonable
suspicion exists to endanger the safety and health of patients or users, is pro-
hibited by Medical Device Law §4, Abs.1 No. 1 and therefore requires its own
conformity check.
6.2.1 Replacing the LED lamp
Danger from hot lamp.
Risk of burn injury.
4 Do not touch lamp after previous operation. Allow the lamp to cool down.
CAUTION
CAUTION
WARNING
CAUTION
16 / 28
Advertisement
Table of Contents
