Operation; Connecting The Coupling To The Hose; Removing The Coupling From The Hose; Attaching Instruments - KaVo MULTIflex LED coupling 460 LED Instructions For Use Manual

Instructions for use MULTIflex LED coupling 460 LED - 1.007.3201
5 Operation | 5.1 Connecting the coupling to the hose

5 Operation

NOTE
At the beginning of each workday, the water-conducting systems should be
rinsed for at least 2 minutes (without transmission handpieces being at-
tached) and if there is a risk of contamination from reflux or back suction, the
system may also need to be rinsed for 20 to 30 seconds after each patient.

5.1 Connecting the coupling to the hose

Malfunction from grasping the regulating ring.
Product defects.
4 Do not grasp the regulating ring.
4 Plug the MULTIflex coupling onto the turbine hose and secure it tightly with
the union nut screw of the hose.
4 Re-tighten with the enclosed wrench.
4 Apply a small amount of KaVo Spray to the O-rings on the supply hose.
The coupling remains screwed onto the hose.

5.2 Removing the coupling from the hose

NOTE
The coupling remains screwed to the hose, use the wrench to remove it.

5.3 Attaching instruments

Detaching the medical device during treatment.
A medical device that is not properly locked can detach from the coupling dur-
ing treatment.
4 Before each use, check if the medical device is securely locked onto the
coupling.
Inexact coupling.
Reduces the service life of the lamp.
4 Avoid inexact coupling.
4 Check the secure fit of the (LUX) handpieces on the coupling by pulling on
them.
4 Accurately attach the MULTIflex (LUX) instrument to the MULTIflex coupling
and push it to the rear until the coupling audibly locks into the medical
device.
CAUTION
WARNING
CAUTION
14 / 28