Table of Contents
Advertisement
Issue
Food remnants on dishware.
Detergent residue in the appliance Lid of the detergent dispenser is blocked by items of dishware and will not open.
Water spots on plastic parts.
Cause and troubleshooting
Dishware was placed too close together or rack is overfilled.
Arrange dishware with sufficient space in between.
1.
The spray jets must reach the surfaces of the dishware.
Avoid points of contact.
2.
Spray arm rotation of the lower spray arm is blocked.
Arrange dishware so it does not obstruct spray arm rotation.
▶
Spray arm nozzles are blocked.
Clean the Spray arms → Page 23 .
▶
Filters are dirty.
Clean the filters.
▶
→ "Cleaning filters", Page 22
Filters are inserted incorrectly and/or not engaged.
Insert the filters properly.
1.
→ "Filter system", Page 22
Twist filters into place.
2.
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Tall narrow containers in corner areas are not rinsed out adequately.
Do not position tall narrow containers at too great an angle or in corner areas.
▶
Upper rack on right and left not set to same height.
Set the upper rack on the left and right to the same height.
▶
→ "Upper rack", Page 11
Arrange dishware in the upper rack so the tab collecting tray is not obstructed by
1.
dishware.
→ "Loading dishware", Page 15
Items of dishware are blocking the dispenser lid.
Do not place dishware or fragrance dispensers in the tab collecting tray.
2.
The lid of the detergent dispenser is blocked by the tab and will not open.
Position the tab in the detergent dispenser crosswise, not vertically.
▶
Tabs are used in the quick or short cycle. There is not enough time for the tab to
dissolve.
Select a more intensive Wash cycle or use Powder detergent.
▶
Detergent may lose its cleaning or dissolving ability after being stored a long time,
or the detergent is clumped together.
Change your Detergent.
▶
Droplet formation on plastic surfaces is unavoidable due to the laws of physics.
Water spots are visible after drying.
Select a more intensive program.
▶
Position dishware at an angle.
▶
→ "Loading dishware", Page 15
Use rinse aid.
▶
→ "Rinse aid", Page 12
Troubleshooting en-us
27
Advertisement
Table of Contents
