Wiper Operation - Honda CR-V 2018 Owner's Manual

VEHICLE CONTROLS
If you find the timing of beam changes inconvenient for driving, change the headlight
beams manually.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the windshield, be
careful not to apply windshield cleanser to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair of the area near the
camera, consult a dealer.
If you see the message " Some Driver Assist Systems Cannot Operate: Clean
Front Windshield," park your vehicle in a safe place. Wipe away debris blocking the
windshield, then start driving again. If the message remains even after driving for a
while with the clean windshield, have your vehicle checked by a dealer.
If the message appears:
• Use the climate control system to cool down the interior and, if necessary, also
use the defroster mode with the air flow directed towards the camera.
• Start driving the vehicle to lower the windshield temperature, which cools down
the area around the camera.
48 |

Wiper Operation

The windshield wipers and washers can be used when the vehicle is on.
n Front Wipers
Move the wiper lever up or down to the desired position.
Intermittent (INT) Wipers
n *1
When you move the lever to the INT position, the
wipers operate based on the delay adjustment.
Rotate the adjustment ring to adjust the wiper delay.
VEHICLE CONTROLS
MIST
OFF
INT *1 : Low speed intermittent
: Automatic intermittent
AUTO *2
operation
Pull to use
LO: Low speed wipe
washer.
HI: High speed wipe
INT position
Intermittent Time
Adjustment Ring*
Lower speed
Higher speed
*1 models without automatic intermittent wipers
*2 models with automatic intermittent wipers
*if equipped
| 49