Table of Contents
Advertisement
VEHICLE CONTROLS
Auto High-Beam System*
Automatically changes the low beam headlights to high beam headlights when
necessary.
How It Works
When you are driving at night above 25 mph (40 km/h) and the headlight lever is
in the low beam position with the switch rotated to AUTO, the system changes
between low and high beams depending on the surrounding conditions.
Your vehicle
If a vehicle is detected ahead of you, the headlights stay in low beams. If the
system does not detect any vehicles ahead of you, the headlights change to high
beams.
Certain conditions, such as weather and brightness of other vehicles' lights, can
affect system operation.
Turning the System On or Off
Make sure the headlight lever is in the low beam
position with the switch rotated to the AUTO
position. The auto high-beam system indicator
comes on.
The system is canceled temporarily when you drive at speeds below 15 mph (24
km/h), the vehicle speed is below 6 mph (10 km/h), or the windshield wipers run at
high speed for more than a few seconds.
To disable the system: When the vehicle is on and parked, pull the headlight lever
towards you and hold it for 40 seconds. The auto high-beam indicator blinks twice.
To re-enable the system: Pull the headlight lever towards you and hold it for 30
seconds. The auto high-beam indicator blinks once.
To temporarily cancel operation, do either of the following:
• Flash the high beams by moving the lever toward you. Flash the high beams
again to resume auto high beam operation.
• Engage high beams by moving the lever into the high beam position. Return the
lever to the low beam position to resume auto high beam operation.
36 |
Oncoming
vehicle
Vehicle ahead
of you
Headlight
switch
*if equipped
Using the Auto High-Beam System
If you find the timing of beam changes inconvenient for driving, change the
headlight beams manually.
If the Can Not Operate:
message appears, park your vehicle in a safe place.
Wipe away debris blocking the windshield, then start driving again. If the message
remains on even after driving for a while with the clean windshield, have your
vehicle checked by a dealer.
For the auto high-beam system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean.
• When cleaning the windshield, be careful not to apply the windshield cleanser
to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
• If the camera receives a strong impact, or repairing of the area near the camera
is required, consult a dealer.
Wiper Operation
The windshield wipers and washers can be used when the vehicle is on.
Move the wiper lever up or down to the desired position.
Headlight-Wiper Integration*
When the headlights are in the AUTO position, they automatically turn on when
the front wipers operate several times within a certain interval. The headlights
turn off shortly after the wipers are turned off, or if there is enough ambient light.
Intermittent (INT) Wipers*
When you move the lever to the
INT position, the wipers operate
based on the delay adjustment.
Rotate the adjustment ring to
adjust the wiper delay.
VEHICLE CONTROLS
MIST
Pull toward
OFF
you to use
washer.
INT
/ AUTO
*1
*2
LO: Low speed wipe
HI: High speed wipe
INT
position
Lower speed
Higher speed
Adjustment ring
*1: models without automatic intermittent wipers
*2: models with automatic intermittent wipers
| 37
Advertisement
Table of Contents
