Cleaning And Storage; Troubleshooting - Troy-Bilt 49MRBESY966 Operator's Manual

IF...the unit does not turn on or suddenly stops while in use, release
the trigger and allow the unit to cool for 60 seconds.
• When directed to remove the electric start accessory:
1. Remove the drive from the electric start port on the gas-
powered product (Fig. 2).
CLEANING
WARNING:
To prevent serious injury, always unplug the
charger before cleaning the charger.
WARNING:
To prevent serious injury, do not use water
to clean the unit or charger. Do not douse or submerge the
unit or charger in water or any other liquid. Do not use
strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such
as kerosene, can damage plastic.
• Use a small brush or clean, dry cloth to clean the outside of the
unit and charger.
PROBLEM
THE BATTERY WILL NOT CHARGE
The charger is not properly connected to a suitable power source
The charger is not properly connected to the unit
The battery and/or charger are too hot or too cold
The battery and/or charger are no longer functional
THE BATTERY DIES QUICKLY
The battery is not fully charged
The battery and/or charger are no longer functional
THE MOTOR WILL NOT RUN
The battery lacks sufficient charge
The battery is too hot or too cold
The battery and/or motor are no longer functional

CLEANING AND STORAGE

TROUBLESHOOTING

If further assistance is required, contact an authorized service center.
STORAGE
• Always unplug the charger when it is not in use.
• Thoroughly clean the unit and charger. Inspect them for any loose
or damaged parts. Tighten loose screws. If there are damaged
parts, have the unit serviced by an authorized service center.
• Store the unit and charger indoors, in a cool, dry, well-ventilated
area.
• Lock up the unit and charger to prevent unauthorized use or
damage.
• Store the unit and charger out of the reach of children.
SOLUTION
Plug the charger into a 120V 60hz AC source
Fully insert the charger pin into the charging port
Make sure the unit and/or charger are in an appropriate
environment. Refer to Specifications. Allow time for the unit and/or
charger to warm up or cool down.
Refer to the Warranty section for replacement information
Charge the battery completely
Refer to the Warranty section for replacement information
Charge the battery completely
Make sure the unit is in an appropriate environment. Refer to
Specifications. Allow time for the battery to warm up or cool down.
Refer to the Warranty section for replacement information
8