Searching For Digital Terrestrial Tv Channels Manually; Tuning Analogue Television C Hannels - Grundig Fine Arts FLE 91 0 5L Manual

SpECIAL­SEttINGS
Searching­for­digital­terrestrial­
tv­channels­manually
1 Open the menu with »mENu«.
2 Select the line »SOURCE SETUP« with »
or » « and press »oK« to confirm.
Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »oK« to confirm.
Select the option »Air« with »
» « and press »oK« to confirm.
Λ
Caution:
The antenna power supply (line »Active
7
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power«« with »
or » «. Switch on the antenna power supply
Λ
for the antenna with »
5 Select » Digital Manual Tuning« with »
» « and press »oK« to confirm.
Λ
– T he menu appears.
6 Enter the channel number directly with
» « and press »oK« to confirm.
1­...­0
– A fter the search is complete, the channels
found are displayed in the »Results« menu.
7 Press »mENu« to finish the setting.
­ 7 4
ENGLISH
­ - ---------------------------------------------------------------------------------------------------------
v
« or »
v Λ
< >
«, » «, » « or
v
v
< >
« or » « (»On«).
« or
v
tuning­analogue­television­
­ c hannels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
«
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
«
Switching­the­television­to­
­ a nalogue­reception
Note:
Analogue channels can be selected if the
7
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with
» «.
2 Depending on the antenna system, select the
option »Air« or »Cable« with »
>
or » « as the input source and press »oK«
to confirm.
Note:
«
Additional operations are explained in the
7
following sections.
Setting­all­analogue­television­
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
Plug the rooftop antenna cable (for analogue
7
television channels) into the »ANt­IN«
socket on the television.
1 Open the menu with »mENu«.
2 Select the line »SOURCE SETUP« with »
or » « and press »oK« to confirm.
Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »oK« to confirm.
Select the option »Air« or »Cable« with »
>
» «, » « or »
v
firm.
«, »
v Λ
« or »
v
« and press »oK« to con-
Λ
<
«, » «
«
v
«
Λ
<
«,