Table of Contents
Advertisement
15.1 Cleaning recommendation
The appliance detects the type and duration of the ap-
pliance operation and, if necessary, recommends using
the cleaning function.
If lights up in the display when the appliance is
▶
switched off, use the cleaning function as soon as
possible.
To remove the information from the display,
‒
press any button except for the
ever, the information will continue to be dis-
played until the cleaning function has been run in
full.
To reset the cleaning recommendation, press
‒
and hold the
button for approx. four seconds.
The information does not reappear until the appli-
ance has been used again a certain number of
times.
Notes
¡ If the appliance is already dirty, e.g. because you
have used it to cook fatty poultry or roasts, or if you
notice dark patches on the self-cleaning surfaces,
do not wait until this information appears in the dis-
play to run the cleaning function. The more often
you use the cleaning function, the longer the self-
cleaning surfaces will retain their cleaning ability.
¡ After a power failure, the cleaning recommendation
is reset. It is therefore a good idea to run the clean-
ing function after a power failure has occurred.
15.2 Preparing the appliance for the
cleaning function
In order to achieve a good cleaning result, prepare the
appliance carefully.
ATTENTION!
Using oven cleaner on the self-cleaning surfaces dam-
ages the surfaces.
Do not use oven cleaner on the self-cleaning sur-
▶
faces. If oven cleaner does get onto these surfaces,
dab it off immediately using water and a sponge
cloth. Do not rub the surface and do not use abras-
ive cleaning aids.
1.
Remove accessories and cookware from the cook-
ing compartment.
Unhook the shelf supports and remove them from
2.
the cooking compartment.
→ "Shelf supports", Page 20
3.
4.
button. How-
15.3 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
cleaning function is in progress.
▶
▶
▶
Requirement: Prepare the appliance for the cleaning
function. → Page 19
1.
a The display shows the duration. The duration of
2.
a The cleaning function starts after a few seconds and
a Once the cleaning function ends, an audible signal
3.
4.
15.4 Wiping the appliance clean following
the cleaning function
1.
2.
3.
Use a detergent solution and a soft cloth to remove
heavy soiling:
– From the cooking compartment floor
– From the inside of the appliance door
– From the glass cover for the oven light
This prevents stains that cannot be removed.
Remove any objects from the cooking compartment.
The cooking compartment must be empty.
WARNING ‒ Risk of burns!
The outside of the appliance gets very hot when the
Never touch the appliance door.
Allow the appliance to cool down.
Keep children at a safe distance.
Use the function selector to set EcoClean .
one hour cannot be changed.
Use the temperature selector to set the cleaning
setting .
the time counts down.
sounds and the display shows the cooking time as
zero.
Switch off the appliance.
Wipe the appliance clean. → Page 19
Allow the appliance to cool down.
Wipe the cooking compartment clean with a damp
cloth.
Note: Marks may appear on the self-cleaning sur-
faces. Residues of sugar and albumin in the food
are not removed and remain on the surfaces. Red-
dish patches may be left over from salty food – the
spots are not rust. These spots are not harmful.
These marks do not impair the cleaning ability of
the self-cleaning surfaces.
Attach the shelf supports.
→ "Shelf supports", Page 20
EcoClean en
19
Advertisement
Table of Contents
