Omega OF610FX Instruction Manual page 22

Maintenance and Cleaning
Cleaning And Maintenance of the Oven's Front Door Glass
Remove the profile by pressing the plastic latches on both left and right sides as shown in figure 20 and pulling the
profile towards yourself as shown in figure 21. Then remove the inner-glass as shown in figure 22. If required, the
middle glass can be removed in the same way. After cleaning and maintenance is done, remount the glass and the
profile in reverse order. Make sure the profile is properly seated in its place.
Figure 20 Figure 21 Figure 22
Catalytic Walls
Catalytic walls are located on the left and the right side of cavity under the guides. Catalytic walls trap bad smells and
help to obtain the best performance from the oven. Catalytic walls also absorb oil residue and clean your oven while it
is operating.
Removing the catalytic walls
The guides must be pulled out in order to remove the catalytic walls. As soon as the guides are pulled out, the catalytic
walls will be released automatically. The catalytic walls must be changed after 2-3 years.
Rack Positions
It is important to place the wire rack into the oven properly. Do not allow wire rack to touch the rear wall of the oven.
Rack positions are shown in the above image. You may place a deep tray or a standard tray in the lower and upper
wire racks.
Installing and removing wire racks
To remove the wire racks, press the clips and first remove the lower and then the upper side from the mount. Reverse
the procedure to replace the wire racks.
22