Omega OF610FX Instruction Manual page 12

Installation Instructions
For LPG (cylinder) connection, affix a metal clamp on the hose coming from LPG
cylinder. Affix an edge of the hose on hose inlet connector behind the appliance by
pushing to end through heating the hose in boiled water. Afterward, bring the clamp
towards end section of the hose and tighten it with screwdriver. The gasket and
hose inlet connector required for connection is as the picture shown below.
NOTE: The regulator to be affixed on LPG cylinder should have 300 mmSS feature.
For Natural Gas Connection
WARNING: Natural gas connection should be done by an authorized service. For
natural gas connection, place a gasket in the nut at the edge of the natural gas
connection hose. To install the hose on the main gas pipe, turn the nut.
Complete the connection by doing a gas leakage control.
Gas hose passage way
Connect the appliance to the gas piping tap in the shortest possible route and in a
way that ensures no gas leakage will occur.
In order to carry on a tightness and sealing safety check ensure that the knobs on
the control panel are closed and the gas cylinder is open.
WARNING: While performing a gas leakage check, never use any kind of lighter,
match, cigarette or similar burning substance.
Apply soap bubbles on the connection points. If there is any kind of leakage then it will cause bubbling.
While inserting the appliance into place ensure that it is on the same level with the benchtop. If required, adjust the
legs in order the make level with the benchtop.
Use the appliance on a level surface and in a well ventilated environment.
WARNING: Before placing the appliance, check that the local distribution conditions (gas type and pressure) conform
to the product settings
.
12