Table 2- 5: Nominal Traits - Display System; Table 2- 6: Nominal Traits - Data Storage; Table 2- 7: Nominal Traits - Gpib Interface, Video Output, And Power Fuse - Tektronix TDS 430A Technical Reference

Nominal Traits
Table 2- 5: Nominal Traits — Display System
Name
Video Display Resolution
Waveform Display Graticule
Waveform Display Grey Scale
Table 2- 6: Nominal Traits — Data Storage
Name
Capacity, Nonvolatile Waveform Memory
Capacity, Nonvolatile Setup Memory
1
Batteries Required
1
Batteries are not accessible from the outside of the instrument; therefore, a service technician must replace them.
Table 2- 7: Nominal Traits — GPIB Interface, Video Output, and Power Fuse
Name
Interface, GPIB
Interface, RS-232 (Option 13 only)
Interface, Centronics (Option 13 only)
Power Supply, Printer (Option 13 only)
Output, Video
Fuse Rating
1
VGA compatible at 30.6 kHz sync rate.
2
Each fuse type requires its own fuse cap.
2- 6
Description
640 pixels horizontally by 480 pixels vertically in a display area of 5.04 inches horizontally
by 3.78 inches vertically
A single graticule 401 × 501 pixels (8 × 10 divisions, with divisions that are 1 cm by
1 cm)
16 levels in variable-persistence display style
Description
Total capacity is 120,000 points (one to four waveforms acquired with any combination of
record lengths that add up to 120,000 points). For available record lengths, see Record
Length Selection on page 2- - 5 of this chapter.
Ten setups
Two lithium poly-carbon monofluoride. Both are type BR2/3A, UL listed. Both are rated at
3.0 volt, 1.2 amp-hour.
Description
GPIB interface complies with IEEE Std 488.1-1987 and IEEE Std 488.2-1987.
RS-232 interface complies with EIA/TIA 574.
Centronics interface complies with Centronics interface standard C332-44 Feb 1977,
REV A.
Supply Voltage:
Maximum Current:
Provides a video signal
Output is through a rear-panel DB-15 connector.
2
may be used: a 0.25I × 1.25I (UL 198.6, 3AG): 8A FAST, 250 V, or
Either of two fuses
a 5 mm × 20 mm, (IEC 127): 6.3 A FAST, 250 V.
TDS 420A, TDS 430A & TDS 460A Performance Verification and Specifications
+6.5 VDC
2 Amps, DC continuous
4 Amps DC maximum for durations < 10 msec
1
, non-interlaced, with levels that comply with ANSI RS343A.