Advertisement
Reassembly Instructions
Cautions:
a. Before fastening screw, relocate the screw with first thread. Once done fasten the screw.
b. Do not drop, hit or knock the ASO (for ASO version only).
c. Ensure there is click sound after Connector to Terminal engage. Refer to wiring diagram for detail.
d. Take note of live part (red & blue wire) must apply with Heat Sink Paste after wire dressing on area as shown.
Notes: Heat Sink Paste – Dow Corning 340 Heat Sink Compound to be used.
1
Assemble Backplate 10
3
Assemble Mainscord 15 & connect all wires
Apply Heat Sink Paste
5
Assemble Water Tank Assy 4
Published by Philips Consumer Lifestyle
Document No. : CSW-07-081-20617
2
Assemble Ball Swivel 11
Assemble T'stat Bush to Soleplate Mtd Assy
4
with Cover 1
6
Assemble ASO (ASO version only),
connect wire & assemble Lamp Assy 2
Page 10 of 14
For internal use only
Advertisement
