Printer Interface Connection; Setup; Loading Labels Or Tags - SATO CX200 User Manual

Printer Interface Connection

1. Connect the supplied interface cable to the parallel printer port on the
computer.
2. Connect the other end to the parallel input port on the printer.

Setup

Loading Labels or Tags

1. Lift open the top cover.
2. Press the two print head releases back to unlock the print head.
3. Remove any print media or empty label core from the printer.
4. Unwrap the new media, and unwind a few labels from the roll. Labels
should be wound face-in for the best results.
5. Slide the paper guide all the way to the right.
6. Place media roll in the paper tray such that the media unwinds from the
bottom of the roll toward the front of the printer. The label imaging
surface must face up as it passes under the print head.
7. Lift the print head and slip the free end of the media under the print
head.
8. Adjust the paper guide until the media is snug between the paper guide
and the left side of the paper tray.
9. Lower the print head and press it down firmly until it locks closed on
both sides.
10. Close the top cover.
11. Wait until the Ready Indicator glows green and press the FEED button
to feed a label or to resume printing.
Page 4
CX200 User's Guide
PN 9001050 Rev. B