Initial Setup - Crosley C72A-WA Instruction Manual

English
20. Speakers
21. Ground Connector
22. RCA Jacks
23. Auto-stop Switch

Initial Setup

Essential Setup
1. Place the unit on a flat and level surface. The selected location should be stable
and free from vibration.
2. Install the turntable lid to the hinges.
3. Remove the tie-wrap that is holding the tonearm.
4. Remove all packing material from underneath the turntable hub.
5. Install the turntable platter and drive belt accordingly.
6. Slide Tonearm Counterweight onto tonearm with the numbers facing the front of
the turntable, and twist it lightly onto the rear shaft of the tonearm.
7. Adjust the counterweight to set proper stylus pressure.
8. Place the slip mat on top of the turntable platter.
9. Connect the power adaptor to the Power Jack of the unit.
Note: Do not plug the power adaptor to the power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings are
correct. Always turn off the power when connecting or disconnecting.
Turntable Platter and Belt Setup
1. Put the drive belt around the Turntable Hub, and then use the provided drive
belt assembly tool to help pull the belt to fit around the slot of motor pulley.
2. Place the turntable platter through the turntable spindle.
24. Phono/Line Switch
25. Power Jack
26. Spring clip speaker terminals
27. Power Switch
6