Stop The Engine; Move Unit Manually - Ariens EDGE 34 Operator's Manual

WARNING: AVOID INJURY.
Move the steering levers
slowly and keep the throttle at
slow speed until you learn how
to operate the unit.
4. Move steering levers to begin mowing.
Direction Lever Position
of Travel
Forward Push both levers
forward from
neutral position.
Reverse Pull both levers
backward from
neutral position.
Right Push left lever
Turn farther forward
than the right
lever.
Left Turn Push right lever
farther forward
than the left lever.
Stop Return both
levers to neutral
position.
IMPORTANT: Aggressive turning can scuff or
damage lawns. Always keep both wheels
rotating when making sharp turns. DO NOT
make turns with inside wheel completely
stopped. For minimum turning radius, slowly
reverse inside wheel while moving outside
wheel slowly forward.
For Best Mowing Results
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Do not set height of cut too low. For very
tall grass, mow twice.
• Do not travel too fast.
• Mow with the engine set at full throttle.
• When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
2.5 cm (1") at any one time.
• Discharge clippings into areas already cut.
• Vary cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside of mower deck. Clean after each
use.

STOP THE ENGINE

1. Move steering levers to neutral position
and rotate outward.
2. Engage parking brake.
3. Push PTO knob down to off position.
4. Set throttle to slow speed.
5. Turn ignition key to off position and
remove key from ignition.

MOVE UNIT MANUALLY

Bypass the transaxles to move the unit with
the engine off.
IMPORTANT: There is one transaxle bypass
lever on each side of unit. Ensure that both
levers are fully in front or rear position.
1. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
2. Pull both transaxle bypass levers out into
bypass position. See Figure 11.
3. Release parking brake and push unit to
desired location.
4. Engage parking brake.
EN - 13
WARNING: AVOID INJURY.
Wait for all moving parts to
stop before leaving operator's
position.
Figure 11