Table of Contents
Advertisement
Installing your Dual Fuel Range Cooker
Bringing it all together
Installation requirements
THIS COOKER MUST BE INSTALLED
ACCORDING TO BS 6172: 2010 BY A SUITABLY
QUALIFIED GAS SAFE REGISTERED INSTALLER
This modern cooker was manufactured with
parts and materials of the highest quality and was
designed to meet your cooking needs. You should
read this manual so that you are able to use
the cooker correctly and to avoid any potential
problems with using the cooker. The following
information outlines the required rules for correct
installation and service of your cooker. This is
particularly important for the technician who will
install the appliance.
Positioning
The furniture close to the cooker must be
manufactured resistant to temperatures up to
100°C
If the kitchen furniture are higher than the hob
plate of the cooker, it must be at least 10cm away
from the cooker's side.
Surrounding furniture, cabinets and extractor fans
should be positioned in accordance with the
diagram shown in figure 3. If fitted, the extractor
fan must be at least 65cm above the hob.
If no fan is fitted the minimum distance between
the hob and any cabinet or other structure must
be 70cm.
First Use
IMPORTANT: When using your oven for the first time
your cooker may give off an unusual odour from
the heating elements and insulation materials. This
is normal for new cookers. To eliminate this odour
run the oven at 250 degrees for 40-60 mins with the
oven empty.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
11
Installing your Dual Fuel Range Cooker
Unpacking
Carefully unpack and examine the appliance for
any damage. If you think there is a defect, do not
use the appliance and contact Argos Product
Support on 01759 487838.
Packaging materials should be collected
together and disposed of immediately as they
may be harmful to children.
Levelling feet
The height and level of the appliance can be
adjusted by rotating the feet located underneath
the appliance at each corner. Rotate in a
clockwise direction to decrease the height and
anti clockwise to increase the height.
Advertisement
Table of Contents
