Serial Cable Installation
The supplied serial cable must be installed when the TwisTorr 804 FS
Navigator or the optional vent valve have to be controlled by means
of a remote computer.
The cable is installed fixing the 9 pin D-type connector into the P2
serial connector as shown in the following figure.
Figure 39
Procedure to Connect the Serial and I/O ports to
an External Cable
In the following picture, it has showed the right procedure to connect
a cable to the I/O or to the serial port.
A shielded cable of 30 m (maximum length has to be utilized for both
serial and I/O port connection).
TwisTorr 804 FS User Manual / 87-901-052-01 (B.00)
Technical Information
Serial Cable Installation
17
311/332