Using Your Refrigerator; Setting The Controls - Kenmore 795.7107 Series Use & Care Manual

SETTING THE CONTROLS

Temperature
• The refrigerator control is preset at 37°F (3°C) and
the freezer control is preset at 0°F (-18°C). These
are the recommended temperature settings for
normal use and conditions. Wait 24 hours for the
refrigerator and freezer to reach these
temperatures.
• The Refrigerator Temp Control range is from
33°F to 46°F (1°C to 8°C). The lower the number
setting, the colder the refrigerator compartment will
become.
• The Freezer Temp Control range is from -6°F to
8°F (-21°C to -13°C). The lower the number
setting, the colder the freezer compartment will
become.
NOTE: When changing control settings, wait 24
hours before making additional adjustments.
After 24 hours, adjust the compartment temperatures
as desired.
Dispenser
• When you press the Water
button, the Water icon will light
up.
• When you press the Ice Select
button, either the cube or
crushed ice icon will light up.
• Some dripping may occur after
dispensing. It is recommended
to hold your cup beneath the
dispenser for a few seconds
after dispensing to catch all of
the drops.

USING YOUR REFRIGERATOR

20
w w CAUTION: The control display is operated by
touch. Excessive moisture on the display may
cause a malfunction. Please keep display clean
and dry.
NOTE: The dispenser will not work if any door is left
open.
Ultra Ice
• When you touch the Ultra Ice button, the graphic
[ ] will light up in the display and will remain on
for 24 hours. It will automatically shut off after
24 hours have passed.
You can stop this function manually by touching the
button one more time.
• This function increases both icemaking and
freezing capabilities.
Filter Reset
• When the water filter indicator (
you have to change the water filter. After changing
the filter, press and hold the Ultra Ice (Filter Reset)
button for 3 seconds to turn the indicator light off.
You need to change the water filter approximately
every 6 months.
Light / Light Sensor
• If the light is set to "Auto" mode, dispenser light will
automatically turn on and off according to the
brightness of the room as detected by the light
sensor.
Energy Saver
• Press and hold the
3 seconds to activate or deactivate the function.
• This function deactivates heaters used to reduce
excess exterior moisture and is recommended for
increased energy savings.
• The energy saving function is also recommended
for periods of time when the doors will not be
opened, such as vacations.
) turns on,
button for at least