Kenmore 795.7107 Series Use & Care Manual page 12

HOW TO REPLACE DOOR HANDLES
NOTE: Handle appearance may vary from
illustrations on this page.
1. Replacing Refrigerator Door Handle
• Place the handle on the door, fitting it over the
mounting fasteners and tighten the set screws with a
3/32" (2.5mm) Allen wrench.
NOTE: If the handle mounting fasteners need to be
tightened or removed use a 1/4" (6.4mm) Allen wrench.
2. Replacing Freezer Drawer Handle
• Place the handle on the door, fitting it over the mounting
fasteners and tighten the set screws on the bottom of the
handle with a 1/8" (3.1mm) Allen wrench.
NOTE: If the handle mounting fasteners need to be tightened
or removed use a 1/4" (6.4mm) Allen wrench.
w w WARNING
When the customer takes apart the handle or
assemble it from a refrigerator, please be cautious of
following things.
• Hold the handle with your own hand to make sure
not to drop the handle to the floor or instep while
taking apart the handle from a refrigerator.
• Do not swing the handle towards people or animals
after taking apart the handle.
• Insert the bracket hole of the handle into the stopper
bolt of the door exactly, and then assemble the set
screws to fix the handle.
• Check if there's any gap between the door and
handle after fixing the handle.
REFRIGERATOR INSTALLATION
12
Mounting
Fasteners