JUMPER SETTING AND CONNECTOR
2.2
J
S
O
UMPER
ETTING
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
your SBC to match the need of your application. To set a jumper, a black plastic cap
containing metal contacts is placed over the jumper pins as designated by the required
configuration as listed in this section. A jumper is said to be " on " or " 1-2 " when the black
cap has been placed on two of its pins, as shown in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have any
doubts about the best hardware configuration for your application, contact your local sales
representative before you make any changes. In general, you simply need a standard
cable to make most connections.
~5~