NETGEAR M4350 Series Hardware Installation Manual page 66

To connect a console to the switch:
1. Connect the USB Type C cable to the USB Type-C console port on the front panel
of the switch.
2. Connect the other end of the cable to your computer, workstation, or terminal.
• On a Windows-based computer, you can use HyperTerminal or install another
terminal emulator such as Tera Term.
• On a Mac operating system, you can use ZTerm.
• On a UNIX workstation, you can use a terminal emulator such as Minicom.
3. If you attach a computer or workstation, start a terminal emulation program.
4. If you attach a computer or workstation, configure the terminal emulation program
to use the following settings:
• Baud rate: 115,200 bps
• Data bits: 8
• Parity: None
• Stop bit: 1
• Flow control: None
After you connect a console to the switch, you can configure the switch. For
information about configuring the switch using the command-line interface (CLI),
see the CLI manual, which you can download by visiting
netgear.com/support/download.
For information about configuring the switch through the main local browser user
interface (main UI) or the audio-video (AV) local browser user interface (UI), see the
users manuals, which you can also download by visiting
netgear.com/support/download.
Installation
Fully Managed Switches M4350 Series
66 Hardware Installation Guide