NETGEAR M4350 Series Hardware Installation Manual page 43

• APS600Wv2: +56 VDC, 11A DC output
• APS920W: +54.5VDC, 16.88A DC output
• APS2000W: +54.5 VDC, 18.35A @ 90–136 VAC DC output; +54.5 VDC, 29.36A @
180–220 VAC DC output; +54.5 VDC, 36.7A @ 220–264 VAC DC output
For information about purchasing an optional APS, contact NETGEAR or your local
NETGEAR reseller.
The following table describes the available APSs and the possible configurations
Table 12. Supported APSs
Switch Model PoE
Supported
M4350-8X8F No
M4350-12X12F No
M4350-24G4XF Yes
M4350-48G4XF Yes
M4350-24X4V Yes
M4350-24F4V No
M4350-44M4X4V Yes
1. If you install a more powerful APS (an APS2000W), the PoE budget does not increase.
2. If you install a more powerful APS such as an APS920W or APS2000W, the PoE budget does not increase.
3. Although you can install a more powerful APS, you can use the APS only for redundancy.
Hardware Overview
Fully Managed Switches M4350 Series
Internal PSU Bays
PSU
240W None
240W None
780W 1
400W 2
780W 1
240W 1
400W 2
43
Possible APS N+1 Power
Configurations Redundancy
Supported
-- No
-- No
1x APS350W or Yes
1x APS600Wv2 or
1x APS920W
1x or 2x APS350W Yes
1x or 2x APS600Wv2
1x or 2x APS920W
1x or 2x APS2000W
or any combination of
these APSs.
1x APS350W or Yes
2
1x APS600Wv2
3
1x APS350W Yes
1x or 2x APS350W Yes
1x or 2x APS600Wv2
1x or 2x APS920W
1x or 2x APS2000W
or any combination of
these APSs.
Hardware Installation Guide