To Connect The Dhw Output; Configuration; Overview: Configuration - Daikin Altherma ELSH12P30E Series Installation Manual

—
1 Open the following (see "4.2.1 To open the indoor
1 User interface panel
2 Switch box
3 Switch box cover
4 Top cover
2 Connect the solar input cable as shown in the illustration below.
3 Fix the cable with cable ties to the cable tie mountings. General
information, see "6.3.1 To connect the electrical wiring to the
unit" [ 4 22].
indoor
6.3.16

To connect the DHW output

Wires: 2×0.75 mm²
Maximum running current: 0.3 A, 230 V AC
—
1 Open the following (see "4.2.1 To open the indoor
1 User interface panel
2 Switch box
3 Switch box cover
4 Top cover
2 Connect the DHW signal cable as shown in the illustration
below.
ELSH/X(B)12P30+50E
Daikin Altherma 3 R MT ECH₂O
4P708484-1 – 2023.03
unit" [ 4 13]):
4
3
2
1
3 Fix the cable with cable ties to the cable tie mountings. General
information, see
unit" [ 4 22].
indoor
7

Configuration

INFORMATION
Cooling is only applicable in case of reversible models.
7.1

Overview: Configuration

This chapter describes what you have to do and know to configure
the system after it is installed.
NOTICE
This chapter explains only the basic configuration. For
more detailed explanation and background information,
see the installer reference guide.
Why
unit" [ 4 13]):
4 If you do NOT configure the system correctly, it might NOT work as
expected. The configuration influences the following:
3
2
▪ The calculations of the software
1
▪ What you can see on and do with the user interface
How
You can configure the system via the user interface.
▪ First time – Configuration wizard. When you turn ON the user
interface for the first time (via the unit), the configuration wizard
starts to help you configure the system.
7 Configuration
"6.3.1 To connect the electrical wiring to the
Installation manual
33