Installation - Amplicomms TCL 410 Operating Instructions Manual

G
ETTING STARTED

Installation

Attention: Only use the power adapter plug contained in the
material supplied since other power adapter plugs could
damage the product. Ensure access to the power adapter
plug is not obstructed by furniture or such. The socket-outlet
shall be installed near the equipment and shall be easily
accessible.
Back-up battery
With the back-up battery (CR2032 Lithium battery) installed, the
clock will keep the time and alarm settings in the event of a power
cut or the DC adaptor being unplugged. During a power cut, the
clock will not display the time, and the alarm function will not
work. If no battery is installed and a power cut occurs, then the
clock will lose its time and alarm setting. This is important as if
there is a power cut in the night then the alarm will not be set
correctly to wake you up in the morning at the required time.
Check the battery condition after one year, replace an old battery.
A leaking battery can destroy your clock.
For replacing the battery, place your unit face down on a flat surface.
Use screw driver to open the backup battery compartment door
located on the back of the unit. Slide and remove the battery cover.
Insert one new CR2032 lithium battery into the battery compartment
with the "+" side facing up as indicated. Close the battery
compartment door and tighten the battery door screw.
Helpline UK 0844 800 6503
19
(See chapter "Helpline" for costs and hours of operation)