Table of Contents
Advertisement
2-2 Rear View
Power Connector (AC IN)
This connector accepts standard AC power cord.
2-3 Operation Panel
* The TEST key and the position keys function only when the SETUP LED is lighted.
SETUP LED
This lights up when the SETUP key is pressed.
Cutting can be performed when this is lit.
PAUSE LED
This lights up when the PAUSE key is pressed
to pause the CM-24/12.
PEN MODE LED
This lights up when the PEN MODE key is pressed.
REPLOT LED
This lights up when the REPLOT key has been
pressed.
TEST LED
This lights up when the TEST key is pressed.
(Position Keys)
These are used to move the material or the
cutting carriage.
POWER/ERROR LED
This lights up when the power is switched on,
and flashes when an error is generated.
The PEN MODE LED and POWER/ERROR LED blink simultaneously.
This flashes if the location of the pinch rollers is not correct.
If DIP switch SW-9 on the CM-24 is set to ON (piece material) and material with a vertical length of 100 mm (3-15/16") or less has been loaded, or if
SW-9 is set to ON and there is no material over the front and rear paper sensors.
For more details, see "3-5 Loading the Material".
6
All manuals and user guides at all-guides.com
Sheet Loading Lever
This moves the pinch rollers up and down to load and release the material.
Power Switch
ON when switched to [I].
OFF when switched to [O].
SETUP Key
Press this to detect the width of the loaded
material and enable the unit for cutting.
Pressing this while operation is paused deletes
the data sent from the computer.
PAUSE Key
When pressed once, this temporarily halts
cutting in progress. Pressing this key again
releases the paused state.
PEN MODE Key
Press this to perform plotting with a pen on
paper. (Be sure to load a pen in the cutting
carriage.)
REPLOT Key
This repeats the same cutting operation.
TEST Key
This performs a cutting test to check whether
blade force is correct.
ORIGIN SET Key
This sets the origin point for cutting to the
current tool position.
Advertisement
Table of Contents
