Settings For Each Function; Using A Material Effectively And Cutting Along The Vertical Dimension (Rotate Function) - Roland CAMM-1 CM-24 User Manual

4 Settings for Each Function

4-1 Using a Material Effectively and Cutting along the
Vertical Dimension (Rotate Function)
This function sets the origin point at the bottom right and rotates the text or graphics 90° (see pictures below). This function is used when
the intended design will not fit in the width (horizontal dimension) of the material, such as long strings of text. If there is still unused
material on the right side, rotation allows you to use this remaining material effectively.
When the character string "Roland" is rotated by 90°, the X axis, Y axis, and origin change as follows:
°
0 Rotation - Rotate OFF
Origin
* The pairs of arrows indicate the positive directions along the X and Y axis.
1
Turn off the power.
POWER/ERROR LED goes out
3
Turn on the power.
POWER/ERROR LED lights up
5
Send cutting data from the computer.
All manuals and user guides at all-guides.com
°
90 Rotation - Rotate ON
2
Set DIP switch SW-6 to ON (rotate).
ON
4
Press the SETUP key.
The SETUP LED lights up
The SETUP LED lights up and the tool carriage
moves to the left and right, then returns.
Canceling the Rotate Function
Switch off the power to the CM-24/12, then set DIP switch
SW-6 to OFF (do not rotate).
Origin
21