Table of Contents
Advertisement
Performing a Self-test
The CM-24/12 is equipped with a "self-test" function to conveniently allow you to check whether or not it is capable of operating
normally. If the CM-24/12 is not performing correctly, follow the steps below to perform a self-test.
A computer is not required in order to carry out the self-test.
1
Refer to "3-3 Installing a Blade" and install a blade
holder (or pen) in the CM-24/12's cutting carriage.
3
Hold down the
key on the panel while you turn the
power on.
5
Press the SETUP key.
Demo cutting starts.
The SETUP LED lights up
Operations is normal if the figure shown at right is cut.
20
All manuals and user guides at all-guides.com
2
Set the blade force to the smallest possible value (the
pen force slider should be at the furthest point to the
left). If after the cutting test you feel that the material
was not cutout clean enough, you can try gradually
increasing the blade force until you have the optimum
level.
4
Load the material (or some paper), following the
procedure described in "3-4 Loading the Material" .
* If a pen and material have been loaded, press the
PEN MODE key to light up the PEN MODE LED.
Advertisement
Table of Contents
