Table of Contents
Advertisement
4-3 Repeating the same cutting
The CM-24/12 can store the data sent from the computer in a buffer (a temporary memory area), and use this data to repeat cutting. When
the SETUP key has been pressed and cutting data is sent, the data is stored in the buffer at the same time that it is cut. After cutting has
finished, the data that has already been sent can be used to perform cutting again until the SETUP key is pressed.
• Even when the SETUP key has been pressed to cancel the setup state (making the SETUP LED go dark), the data for repeating
cutting is not erased until new data is sent from the computer.
• When the power is switched off, any existing data in the buffer is deleted.
• If the buffer becomes full while data is still being sent, replotting (recutting) cannot be performed.
Pressing the REPLOT key while in this state makes the REPLOT LED start to flash.
• Pressing the REPLOT key while the buffer contains no data makes the REPLOT LED start to flash.
1
Install a blade and load
material on the CM-24/12.
4
[Repeating cutting on the same material]
1) After cutting finishes, use the
the center of the blade holder. Move it to the point where the
origin is to be set.
[Repeating cutting on different material]
1) After cutting finishes, press the
SETUP key. Hold down for
about 1 sec.
The SETUP LED
goes out
5
Press the REPLOT key.
The REPLOT LED lights up
Recutting starts.
All manuals and user guides at all-guides.com
2
Press the SETUP key.
The SETUP LED
lights up
,
,
, and
keys to move
2) Remove the material and load a
different piece of material.
3
The unit will begin cutting
when it receives cutting data
sent from the computer.
2) Press the ORIGIN SET key.
The SETUP LED flashes once and the
origin point is set.
3) Press the SETUP key.
The SETUP LED
lights up
To stop repeated cutting
1) Press and hold the PAUSE key until the PAUSE LED lights
up.
2) Press the SETUP key. Hold down for about 1 sec. (The
SETUP LED goes out.)
23
Advertisement
Table of Contents
