Connecting The Cy-15R Or Cy12-R/C (Three Way Triggering Function) - Roland TMC-6 Owner's Manual

2. Set the trigger type as shown below.
Plug TRIGGER INPUT
White
Red
■ Connecting the CY-15R or CY12-R/C
(Three Way Triggering Function)
When you connect the CY-15R or CY-12R/C and the TMC-6 with two stereo
cables, you can play different sounds with these pad's bow, bell, and edge
(Three Way Triggering).
1. Connect the CY-15R's or CY-12R/C's two outputs to two of the TMC-6's
TRIGGER INPUTS as shown below.
fig.05-04
2. Set the trigger type as shown below.
OUTPUT
BOW/BELL
BOW/EDGE
* If you are using the trigger input 1 and 2, be sure to set the trigger type of trigger 2
Rim to "
Correspondences Between Playing Methods and Trigger Input
Playing Methods
Bow Shot
Bell Shot
Edge Shot
* Head-side tones for the trigger input 2, 4, and 6 cannot be sounded.
If you use two cables to connect the CY-15R or CY-12R/C to the TMC-6
without using the "
the sounds of both the bow and edge to be heard. Furthermore, trigger chase
will not occur correctly.
If the trigger type is set to "
processing so that the sound of the pad set to "
when a trigger signal is input to the trigger input set to "
TRIGGER TYPE
2 (Head)
2 (Rim)
TRIGGER INPUT
1 3
2 (Head) 4
*
."
TRIG INPUT
1, 3, 5 (Head)
1, 3, 5 (Rim)
2, 4, 6 (Rim)
" trigger type, striking the bow (or edge) will cause
," the TMC-6 will perform internal
Example of Connections and Settings
Ride
CY-15R
Trigger Type
5
6
" will not be played
." In order to
If you use a single cable to
connect the CY-15R or CY-
12R/C, set the trigger type
to " ". If the trigger
type is set to " "
when the cymbal is
connected via a single
cable, the sound will not
be played.
19