Troubleshooting Guide - EINHELL 3408304 Operating Instructions Manual

10. Troubleshooting guide

Danger!
Before troubleshooting, switch off the equipment and remove the battery.
The table below contains a list of problems and explains what you can do to fi nd a solution to the
problem if your equipment fails to work properly. If you fail to localize and solve the problem after working
through the list, please contact your nearest service center.
Problem
The equipment
does not work.
The equipment
stops during cutting.
The cutting blade
becomes jammed in
a thick branch.
The cut is not
smooth.
Anl_GE-LS_18_Li-Solo_SPK7_USA.indb 13 Anl_GE-LS_18_Li-Solo_SPK7_USA.indb 13
EN
Possible cause
- Set the ON/OFF main switch to the
OFF position.
- Battery empty.
- Battery is not correctly inserted.
- Battery empty.
- Battery capacity low.
- Battery capacity low.
- Wood too hard.
- Wood diameter too large.
- Cutting blade is blunt or worn.
- 13 -
Solution
- Set the ON/OFF main switch to ON.
- Charge battery.
- Remove battery and insert again
(see section 5.2).
- Charge battery.
- Charge battery.
- Charge battery.
- Wood is unsuitable for cutting.
- Wood is unsuitable for cutting.
- Replace cutting blade.
23.11.2022 13:56:21 23.11.2022 13:56:21