Advertisement
SI-AD4 / SO-DA4 Installation Manual
Installing an SI-AD4/SO-DA4
1
Remove the two screws from each module (SI-AD4 or SO-DA4) installed in the
S-4000S.
2
Extract the module from the S-4000S.
Installing an SI-AD4/SO-DA4
1
Load the modules (SI-AD4 or SO-DA4) into the S-4000S.
2
Align the module's circuit board with the slot in the S-4000S, and insert
slowly.
3
Press in the module firmly until you feel resistance.
4
Secure the module in place using the two screws removed when detaching
the module.
Refer to the Service Notes issued by Roland and perform the operational checks
necessary to ensure that each module has been installed correctly.
2
The module shown in the
figure is the SO-DA4. The
removal procedures for the
SI-AD4 and SO-DA4 are the
same.
Extraction of the SI-AD4 or
SO-DA4 may be accomplished
more easily by inserting an
XLR plug into a connector on
the module, then pulling out
the module while gripping the
plug.
Advertisement
