Back Panel Connectors - Gigabyte W480 VISION D User Manual

1-7

Back Panel Connectors

USB 2.0/1.1 Port
The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices.
USB 2.0/1.1 Port (Q-Flash Plus Port)
The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices. Before using Q-Flash
Plus , make sure to insert the USB flash drive into this port first.
(Note)
DisplayPort In port
The DisplayPort In port offers video outputs to the motherboard. Refer to the Thunderbolt
for more information.
HDMI Port
You can use this port to connect your HDMI-supported monitor. The maximum supported resolution is
4096x2160@30 Hz, but the actual resolutions supported are dependent on the monitor being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(The item name may differ depending on your operating system.)
SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
Tighten the antennas to the antenna connectors and then aim the antennas correctly for better
signal reception.
USB 3.2 Gen 2 Type-A Port (Red)
The USB 3.2 Gen 2 Type-A port supports the USB 3.2 Gen 2 specification and is compatible to the USB
3.2 Gen 1 and USB 2.0 specification. Use this port for USB devices.
Thunderbolt
™
The connector supports standard DisplayPort and Thunderbolt
DisplayPort/Thunderbolt
daisy chain up to six Thunderbolt
the number of Thunderbolt
devices being installed. You can adjust the Thunderbolt
Configuration in BIOS Setup. The maximum supported resolution is 5120x2880@60 Hz with 24 bpp, but
the actual resolutions supported are dependent on the monitor being used. Also, the connector is reversible
and supports the USB 3.2 Gen 2 specification and is compatible to the USB 3.2 Gen 1 and USB 2.0
specification. You can use this port for USB devices, too.
(Note) To enable Q-Flash Plus function, refer to Chapter 5, "Unique Features," for more information.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
The HDMI port supports HDCP 2.3 and Dolby TrueHD and DTS HD Master Audio
formats. It also supports up to 192KHz/16bit 7.1-channel LPCM audio output.
3 Connector (USB Type-C
monitor to this connector with an adapter. The Thunderbolt
™
devices. Because of the limited I/O resources of the PC architecture,
™
devices that can be used is dependent on the number of the PCI Express
™
Port)
™
video outputs. You can connect a standard
™
settings under Settings\IO Ports\Thunderbolt(TM)
™
- 21 -
3 Connector
™
connector can
™
Hardware Installation