Table of Contents
Advertisement
AUTO mode operation
■ Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on.
• If you do not want the AUTO mode program,
change to COOL, HEAT or FAN instead of
AUTO.
• Airflow direction adjustment procedure.
NOTE
• In case air is not blowing out during the
operation.
FAN SPEED
■ The FAN SPEED can be set without DRY mode.
1
2
3
When it is a little cold
Press the
■ Each time the
–6 → –5 → ............ –1 → ±0 → +1 ............ +6.
When +6 is indicated, even if the
When it is a little hot
Press the
Page 11
■ Each time the
Page 12
+6 → +5 → ............ +1 → ±0 → –1 ............ –6.
When –6 is indicated, even if the
Setting
temp.(°C)
Page 21
1
Operation capacity by your choice
Set automatically by microcomputer
Powerful operation with high capacity
Standard operation
Energy-saving operation
• When FAN SPEED is changed from HI to LO, the sound of refrigerant
may be heard.
EN-10
Press the MODE button.
The mode changes whenever the button is pressed.
Set to
.
Press the ON/OFF button.
Press the
or
button.
Default preset temperature during AUTO mode is 24°C for both cooling and
heating mode. However, it can be adjusted (Minimum 18°C, Maximum 30°C)
using
button or
button.
button.
button is pressed, the switch over occurs in the following order
button is pressed, the indicator does not change.
button.
button is pressed, the switch over occurs in the following order
button is pressed, the indicator does not change.
Remote Control display
-6
-5
-4
-3
-2
-1
18
19
20
21
22
23
To stop:
Press the ON/OFF button.
Press the FAN SPEED button.
Each time the button is pressed, the fan speed changes.
AUTO
HI
MED
NOTE
+ 0
+1
+2
+3
+4
+5
24
25
26
27
28
29
LO
FAN SPEED
AUTO
HI
MED
LO
+6
30
Advertisement
Table of Contents
