Airflow Direction Adjustment - Mitsubishi Heavy Industries LMK Series User Manual

Airflow direction adjustment

■ Up/down direction can be adjusted with the AIR FLOW button on the remote control. Every time you press this button, the mode
changes as follows:
Change on AIR FLOW (UP/DOWN) mode.
NOTE
• The actual position of the flap and louver may differ from the display shown.
NOTE FOR HEATING OPERATION
• When heating operation starts, the flap direction is fixed at the horizontal position in order to avoid cold draft. It returns to the set
position when the warm air supply is started.
• The flap direction will be controlled to the horizontal position when the room temperature reaches the set temperature and compressor
stops or when defrosting is in operation.
• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is
supplied and the flap goes to the set position.
Memory flap (Flap stopped)
When you press the AIR FLOW button once while the flap is operating, it stops swinging at the position. Since this angle is
memorized in the microcomputer, the flap will automatically be set at this angle when the next operation is started.
• Do not expose directly to airflow from the air-conditioner for a long time.
• When in COOL or DRY operation, do not operate for a long period with the
airflow blowing straight down. Otherwise, condensation may appear on the
outlet grill and drip down.
• Do not try to adjust the flaps by hand, as the control angle may change or
the flap may not be closed completely.
■ Adjust the direction by moving the left/right louver by hand.
When you adjust the direction, touch the operation point of louver.
• Please stop the air-conditioner when adjusting the air fl ow direction.
(Flap stopped)
WARNING
CAUTION
Adjusting left/right air fl ow direction
CAUTION
EN-12
• Recommended angle of the flap when
stopping
(Slant forward
HEAT
blowing)
(Horizontal
COOL, DRY
Operation point
Louver
Flap
(Swing)
blowing)