General Information; General Description - Bosch Worcester benchmark 9/14CBi User Instructions & Customer Care Manual

GENERAL
INFORMATION
GAS SAFETY (INSTALLATION AND USE)
REGULATIONS 1998
It is the law that all gas appliances must be installed by a
competent person in accordance with the above regulations. Failure to
install appliances correctly could lead to prosecution. It is in your
interest and that of safety to ensure compliance with the law. The
manufacturers notes must not be taken, in any way, as over-riding
statutory obligations.
WARNING: This appliance must be earthed and protected by a 5
amp fuse.
ELECTRICITY SUPPLY: 230V ~ 50Hz
IMPORTANT: To get the best from your Worcester boiler please
read these instructions carefully.
In the event of a fault the appliance should not be used until the
fault has been corrected by a competent person.
BENCHMARK
The Benchmark initiative is the new code of practice to
encourage the correct installation, commissioning and servicing of
domestic central heating boilers and system equipment.
The 'log-book' is a vital document that must be completed by the installer
at the time of installation and handed to the householder. It confirms that
the boiler has been installed and commissioned according to the
manufacturers instructions.
Without the completion of the log-book, manufacturers may refuse to
respond to a call-out from a householder, who will be advised that he or
she must call back the installer, who has not fulfilled his obligations to
record the information required by the initiative.
It is important that:
The services and the system are properly flushed as specified.
The user is clearly instructed on the correct operation of the appliance.
The benefits of regular servicing are explained – to maintain the efficiency
and extend the life of the appliance.

GENERAL DESCRIPTION

The Worcester boilers provide a heat output of between 9-14kW
(9/14CBi), 14-19kW (14/19CBi) & 19-24kW (19/24 CBi) and contain a
temperature control and all the appropriate safety controls. They are
suitable for fully pumped open vent or sealed systems.
They can be connected to a domestic hot water supply system
through an external S or Y plan system.
3