Advertisement
All manuals and user guides at all-guides.com
Step 3
Push down release tab (B in Figure 1), pull up the lever (A) on disk to be replaced.
Step 4
Caution Wait 15 seconds for the disk to spin down. There is a danger of damage to the disk if it is dropped
due to gyroscopic effects. Wait for a spinning disk to stop spinning prior to removing it from the product.
Step 5
Pull the disk to be replaced from the slot.
Step 6
Caution DO NOT leave the disk slot empty for more than 5 minutes, as proper cooling/airflow depends on
all slots being full.
Step 7
Verify that the disk module extraction handle (A in Figure 1) is open . Place your thumb behind the
extraction handle and with your finger, push the latch tab (B) toward your thumb.
Note It is important that the new disk is of the same capacity (in GB) or larger than the disk being replaced.
Step 8
Push the replacement disk module, capacity label up, into the empty slot.
Step 9
Push down the lever (A in Figure 1) on the disk. It will click into place.
Step 10
Monitor the LED,
Note The LED should be on while the disk spins up and then turn off. The LED will blink with I/O activity to
the disk. If you observe different results, further Troubleshooting may need to be carried out. (See Chapter
4 of the
HP StorageWorks Disk System 2405 User' s Guide
for troubleshooting procedures.)
Procedure Completed!
Congratulations!
10
Advertisement
