Roland MV-8000 Frequently Asked Questions page 3

Q&A
Q9. I want the high range of a song imported from an audio CD to
be clearer.
Ans.
Use Pre Emphasis.
To turn Pre Emphasis on:
1.
In the IMPORT screen, press [MENU].
2. Select IMPORT OPTION, and press [ENTER].
3. Turn the Pre Emphasis setting On.
Q10. I want to select all note numbers in the PIANO ROLL EDIT
screen.
Ans.
Press [F2 (All Note Sel)]. Select all note numbers as the target for editing in the PIANO ROLL EDIT screen.
Q11a. I want to delete a sample from the sample list.
Q11b. I want to expand the free space of the wave memory.
Ans.
You can't specify and delete a sample.
If the memory is full and you need to delete samples, use "Optimize Project."
In a single step, Optimize Project lets you erase all samples not used in the current project.
1. Press [PROJECT].
2. Select "OPTIMIZE PROJ."
3.
Press [ENTER].
4.
If you are sure you want to delete the unused samples, press [F5 (Yes)].
Q12. When the current track is an audio phrase, why don't I hear
sound when I strike the pads?
Ans 12-1.
In the MIXER screen, could the AUDIO PHRASE Level be set to 0?
• You may not hear sound if the Level is too low.
Ans 12-2.
In the MIXER screen, could the AUDIO PHRASE Output Assign parameter be set to other than Mix?
• If this is set to Off, you won't hear the sound since it is not being output.
• The MLT1~M7/8 settings output the sound via the MV8-OP1.
• Even with the AUX1~4 settings, you may not hear any sound for the same reasons
as described above if the AUX Output Assign is set to other than Mix.
Q13. I want to delete the CLIP BOARD data.
Ans.
Holding down [DELETEJ and press [CLIP BOARD] to delete the clip board data. If deleted the data in CLIP BOARD,
CLIP BOARD indicator will dark.
3