Assign Mode - Roland MT-300S Midi Implementation Manual

MT 300s MIDI Implementation
● Part Parameters
MT-300s has 16 parts. Parameters that can be set individually for each Part are called Part parameters.
If you use exclusive messages to set Part parameters, specify the address by Block number rather than Part Number (normally the same number as the MIDI channel). The Block number can be
specified as one of 16 blocks, from 0 (H) to F (H).
The relation between Part number and Block number is as follows.
x...BLOCK NUMBER (0-F), Part 1 (MIDI ch = 1) x = 1
Part 2 (MIDI ch = 2) x = 2
Part 9 (MIDI ch = 9) x = 9
Part10 (MIDI ch = 10) x = 0
Part11 (MIDI ch = 11) x = A
Part12 (MIDI ch = 12) x = B
Part16 (MIDI ch = 16) x = F
Address (H) Size (H) Data (H)
40 1x 00 00 00 02 00-7F
40 1x 01# 00-7F
40 1x 02 00 00 01 00-10
40 1x 03 00 00 01 00-01
40 1x 04 00 00 01 00-01
40 1x 05 00 00 01 00-01
40 1x 06 00 00 01 00-01
40 1x 07 00 00 01 00-01
40 1x 08 00 00 01 00-01
40 1x 09 00 00 01 00-01
40 1x 0A 00 00 01 00-01
* Rx. NRPN is set to OFF by power-on or by receiving "Turn General MIDI System On," and it will be set ON when "GS RESET" is received.
40 1x 0B 00 00 01 00-01
40 1x 0C 00 00 01 00-01
40 1x 0D 00 00 01 00-01
40 1x 0E 00 00 01 00-01
40 1x 0F 00 00 01 00-01
40 1x 10 00 00 01 00-01
40 1x 11 00 00 01 00-01
40 1x 12 00 00 01 00-01
40 1x 13 00 00 01 00-01
40 1x 14 00 00 01 00-02
* ASSIGN MODE is the parameter that determines how voice assignment will be handled when sounds overlap on identical note numbers in the same channel (i.e., repeatedly struck notes).
This is initialized to a mode suitable for each Part, so for general purposes there is no need to change this.
40 1x 15 00 00 01 00-02
* This parameter sets the Drum Map of the Part used as the Drum Part. MT-300s can simultaneously (in different Parts) use up to two Drum Maps (MAP1, MAP2). With the initial settings,
Part10 (MIDI CH = 10, x = 0) is set to MAP1 (1), and other Parts are set to normal instrumental Parts (OFF (0)).
40 1x 16 00 00 01 28-58
40 1x 17 00 00 02 08-F8
40 1x 18#
* PITCH OFFSET FINE allows you to alter, by a specified frequency amount, the pitch at which notes will sound. This parameter differs from the conventional Fine Tuning (RPN #1) parameter
in that the amount of frequency alteration (in Hertz) will be identical no matter which note is played. When a multiple number of Parts, each of which has been given a different setting for
PITCH OFFSET FINE, are sounded by means of an identical note number, you can obtain a Celeste effect.
40 1x 19 00 00 01 00-7F
40 1x 1A 00 00 01 00-7F
40 1x 1B 00 00 01 00-7F
40 1x 1C 00 00 01 00-7F
40 1x 1D 00 00 01 00-7F
40 1x 1E 00 00 01 00-7F
40 1x 1F 00 00 01 00-5F
40 1x 20 00 00 01 00-5F
40 1x 21 00 00 01 00-7F
40 1x 22 00 00 01 00-7F
40 1x 23 00 00 01 00-01
* Rx. BANK SELECT is set to ON by power-on or by receiving "GS RESET," and will be set OFF when "Turn General MIDI System On" is received.
8
: : :
: : :
Parameter
TONE NUMBER
Rx. CHANNEL
Rx. PITCH BEND
Rx. CH PRESSURE (CAf)
Rx. PROGRAM CHANGE
Rx. CONTROL CHANGE
Rx. POLY PRESSURE (PAf)
Rx. NOTE MESSAGE
Rx. RPN
Rx. NRPN
Rx. MODULATION
Rx. VOLUME
Rx. PANPOT
Rx. EXPRESSION
Rx. HOLD1
Rx. PORTAMENTO
Rx. SOSTENUTO
Rx. SOFT
MONO/POLY MODE
(= CC# 126 01 / CC# 127 00)

ASSIGN MODE

USE FOR RHYTHM PART
PITCH KEY SHIFT
PITCH OFFSET FINE
Use nibblized data.
PART LEVEL
(= CC# 7)
VELOCITY SENSE DEPTH
VELOCITY SENSE OFFSET
PART PANPOT
(= CC# 10, except RANDOM)
KEY RANGE LOW
KEY RANGE HIGH
CC1 CONTROLLER NUMBER 0-95
CC2 CONTROLLER NUMBER 0-95
CHORUS SEND LEVEL
(= CC# 93)
REVERB SEND LEVEL
(= CC# 91)
Rx. BANK SELECT
Description
CC#00 VALUE 0-127
P.C. VALUE 1-128
1-16, OFF
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
OFF/ON
Mono/Poly
0 = SINGLE
1 = LIMITED-MULTI
2 = FULL-MULTI
0 = OFF
1 = MAP1
2 = MAP2
-24 - +24 [semitones]
-12.0 - +12.0 [Hz]
0-127
0-127
0-127
-64 (RANDOM), -63 (LEFT) - +63 (RIGHT) 40
(C-1)-(G9)
(C-1)-(G9)
0-127
0-127
OFF/ON
Default Value (H) Description
00 0
00 1
Same as the Part Number
01 ON
01 ON
01 ON
01 ON
01 ON
01 ON
01 ON
00 (01*) OFF (ON*)
01 ON
01 ON
01 ON
01 ON
01 ON
01 ON
01 ON
01 ON
01 Poly
00 at x = 0 SINGLE at x = 0
01 at x ≠0 LIMITED-MULTI at x ≠0
00 at x ≠0 OFF at x ≠0
MAP1 at x ≠0
01 at x = 0
40 0 [semitones]
08 00 0 [Hz]
64 100
40 64
40 64
0 (CENTER)
00 C-1
7F G 9
10 16
11 17
00 0
28 40
01 (00*) ON (OFF*)