Table of Contents
Advertisement
CAUTION
Do not install the pressure control until motor is
checked. A defective motor may damage the pres-
sure control. Make sure to test the motor prior to
pressure control installation.
WARNING
ELECTRIC SHOCK HAZARD
To reduce the risk of Electric Shock: wait
5 minutes after turning sprayer off before
servicing to allow stored current to dis-
charge.
Motor Test
With motor shield off and four motor leads discon-
nected:
1. Check continuity with multimeter from each black
motor lead to ground (one at a time). Any reading
less than infinite resistance – even very high re-
sistance – means motor is shorted to ground. Re-
place motor.
CAUTION
A motor that is shorted to ground will damage the
pressure control.
2. Remove fan cover from motor.
3. Remove pump pin ( See page 25 for instructions to
remove pin).
4. With black motor leads not connected, use motor
fan to spin motor quickly. Motor should spin freely
in both directions. If not, replace motor.
5. Connect black motor leads together.
6. Use motor fan to turn motor. It should be much
harder to turn than in step 4. If there is uneven or
no resistance to turning, check brushes and re-
place if necessary.
7. If there is still uneven or no resistance to turning,
replace motor.
8. Install pump pin and fan cover.
Pressure Control
Pressure Control Replacement
1. Relieve pressure.
2. Remove two screws (19) holding filter
3. Remove filter assembly by unthreading swivel
4. Remove 8 screws (64) and motor shield (14).
5. Remove outlet cover (221) on pressure control
6. Loosen electrical tubing (22) from pressure control
7. Remove hose (28) from rear of pressure
8. Support pressure control (5) and carefully remove
9. Install new pressure control (5) with screws (37).
10. Continue to assemble sprayer.
WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 8.
WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 8.
assembly (A). See Fig. 14 and parts list, except as
noted.
union (15) from hex nipple (103). Unthread nipple
from pressure control (5)
wiring box. Disconnect motor leads. See Fig 13.
fitting and pull out wires
control swivel union (15).
motor mount screws (37). Remove pressure
control.
Black
Red
Fig 13
Black/White
Black
Yellow
Advertisement
Table of Contents
