Roland Fantom XR User Manual page 22

Changes due to the upgraded editor software
7.
Press [ENTER].
You can press [EXIT] to return to the
preceding step.
8.
STEP 5 will appear.
This screen shows details about the patch
being imported.
fig.06-04_80
If you are satisfied with what the screen
shows, press [ENTER] to begin the import.
You can press [EXIT] to return to the
preceding step.
9.
A screen like the following is shown
during the import.
fig.06-06_80
Never turn off the power while data is
being imported.
If some of the data being imported is
missing, the error message "File Not
Found" will appear. In this case, delete all
of the files in the PATCH_IMPORT folder,
and use Fantom-X Sample Converter to
replace the data.
22
10. When the import is completed, you are
asked whether you can delete the
source files located in the User or Card
PATCH_IMPORT directory.
Press [ENTER] to delete the files. (To
cancel, press [EXIT].)
* It may take some time for files to be deleted.
If the Import was successful, there is
normally no need to keep the source file.
11. Press [ENTER] to return to the normal
screen.
12. Save the sample.
Unlike patches, rhythm sets, and
multisamples, samples are not saved
automatically when the import procedure
finishes. You must save samples as
described in "Saving samples (Save All
Samples)" (p. 24) of the owner's manual.
* In some cases, an imported patch, rhythm set,
or sample may sound differently than when
played back on the S-700 series.