Roland CY-8 Owner's Manual page 10

KD-8
Connecting to a Percussion Sound
Module
1. Use the included connection cable and connect
the output jack of the KD-8 to the trigger input
jack of the percussion sound module.
Connect the L-shaped plug of the included cable to the
KD-8. This will prevent strain from being applied to the
KD-8.
2. Make the trigger settings for the percussion
sound module. For the recommended values,
refer to p. 12.
Should you neglect to make the appropriate settings for
the percussion sound module, you could likely experience
the following problems:
• Sometimes it does not sound (uneven volume)
• The volume is too low (reduced sensitivity)
For information on how to change the parameters for a
percussion sound module, refer to the documentation for
the percussion sound module you're using.
Specifications
KD-8: Kick Trigger Unit
Dimensions: 272 (W) x 260 (D) x 405 (H) mm
10-3/4 (W) x 10-1/4 (D) x 16 (H) inches
Weight: 2.9kg / 6 lbs 7 oz
Accessories: Owner's Manual, Connection Cable, Screws
In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change without
prior notice.
10
962a