Brightness; Temporary Display; Speaker - NAD C399 Owner's Manual

C 389 AS A BLUETOOTH SOURCE
Set "Bluetooth Mode" to "Source". Ensure that the Bluetooth antenna is
connected to the BT antenna terminal at the rear panel.
1 While at Bluetooth Source Mode, press ENTER to select "Source Setup".
2 "Disconnected" will appear in the display. Press ENTER to initiate inquiry
(INQUIRE). The unit searches for available Bluetooth devices within the
same Bluetooth network environment.
3 Toggle a/s to select through available Bluetooth sources. Press to
connect and select preferred Bluetooth Source.
If you would like to disconnect from current Bluetooth device, press
ENTER to select DISCONNECT. Repeat steps 2 to 3 again to select and
connect to another Bluetooth device.
4 Having settled on a Bluetooth Source device, toggle a SOURCE s to
select the source media you would like streamed to the connected
Bluetooth device. For example, if you want to stream audio from
OPTICAL 1, select OPTICAL 1 as the active source. Note the Headphone
and Bluetooth icons in the front panel display as indication that you are
at Bluetooth Source Mode.

BRIGHTNESS

BRIGHTNESS function makes it possible to adjust the brightness level of the
front panel display.
Normal: Display brightness level is normal.
Bright: Display is at its brightest level or above normal brightness level.
Dim: Display is dimmed or below normal brightness level.

TEMPORARY DISPLAY

Temporary Display feature enables the display to be turned off temporarily
after 30 seconds of non-user interface.
On: Display is turned off temporarily after 30 seconds of non- user
interface. The Power Indicator LED is also turned off at the same time.
Display and Power Indicator LED are activated once user interface is
initiated.
Off: Display remains illuminated.

SPEAKER

Select "On" to enable speakers or "Off" to disable speakers.
OPERATION
USING C 389
17