Bluetooth Mode - NAD C399 Owner's Manual

OPERATION
USING C 389
•
Press [ENTER] while still holding down the device button [AMP]. The
AMP device selector will flash once to indicate that the library input is
successful.
With both C 389 and SR 10 set to "Channel 1", the C 389 can now be
remotely controlled independent of the T 758.
NOTE
Performing Factory Reset for C 389 or SR 10 will restore their respective
IR channel setting to "Channel 0".

BLUETOOTH MODE

Bluetooth Mode defines the two roles of the C 389 as either a Bluetooth
Sink or a Bluetooth Source.
Sink: Audio stream is received from a Source on the same Bluetooth
network environment.
Source: Audio is streamed or sent to another device (Sink) on the same
Bluetooth network environment.
IMPORTANT!
1 Bluetooth Mode option is not available if the optional MDC2 BluOS-D is
installed.
2 With no MDC2 BluOS-D installed and "Auto Sense" setting of Bluetooth
source set to "On", C 389 will go to Network Standby mode under the
following condition.
• With a Bluetooth device connected or disconnected, C 389 will go to
Network Standby mode if there is no user interface interaction and
no active source input within 20 minutes.
C 389 will wake up from Network Standby mode by pressing front panel
Standby button or "OFF" button of SR 10 remote control or playback of
Bluetooth connected device.
Power consumption at Network Standby mode is 0.6W.
3 With no MDC2 BluOS-D installed and "Auto Sense" setting of Bluetooth
source set to "Off", C 389 will go to Standby mode if there is no user
interface interaction and no active source input within 20 minutes.
16
C 389 AS A BLUETOOTH SINK
Set "Bluetooth Mode" to "Sink". Initiate pairing of your Bluetooth device with
C 389 by following below procedure.
1 Ensure that the Bluetooth antenna is connected to the BT antenna
terminal at the rear panel.
2 Using your iOS or Android device, go to Settings – Bluetooth and then
scan for Bluetooth devices. Select the unique device ID (example, C389BT)
of your C 389 as listed or selectable in the device list of your Bluetooth
settings. Pair or connect your C 389 and the Bluetooth device.
3 Upon successful pairing of your Bluetooth device and the C 389, front
panel display will show the connected Bluetooth device ID (J's S21 in
this example).