Table of Contents
Advertisement
CRC200
BUS
Fig. 45 Schematic of electrical wiring of Bosch room control and boiler
1)
Terminal at the boiler reads BUS or BB, both indicating
connection of the 2-wired Bosch BUS system.
7.2.3
Connecting the outdoor temperature sensor
▶ Set up WWSD according to the instruction manual of CRC200.
▶ Punch out plastic insert.
▶ Connect cable of the outdoor temperature sensor according to
Fig. 46.
▶ Insert cable for the outdoor temperature sensor.
▶ Secure the cable on the strain relief.
F
A
Fig. 46 Electrical wiring outdoor temperature sensor
7.2.4
Connecting the DHW tank temperature sensor (only ZBR...-
3A)
Wire the DHW tank temperature sensor directly to the appliance
terminals. The sensor is provided with the appliance.
Do not exceed a sensor cable length of 33 feet (10 m).
▶ Punch out plastic insert.
▶ Plug connector into the circuit board.
▶ Insert the cable of the DHW tank temperature sensor.
Greenstar – 6721822579 (2020/03)
1)
BUS/
BB
6 720 811 153-05.1O
6 720 641 933-35.1O
▶ Secure the cable with the strain relief.
Fig. 47 Electrical connections DHW tank temperature sensor
7.2.5
Connecting additional accessories
▶ For splash protection (IP), always cut the strain relief to match the
diameter of the cable.
Fig. 48 Cut off grommets
▶ Feed cable through strain relief and connect accordingly.
▶ Secure the cable on the strain relief.
Connecting temperature guard TB 1 (external manual reset high
limit or low water cut off (LWCO))
This connection allows the installation of external safety switches.
• External manual reset high limit
• Low water cut-off (LWCO)
• Radiant overheat protection
LS NS
Fig. 49 Electrical wiring TB 1
When the temperature guard trips, central heating and DHW modes are
interrupted.
Electrical connection
6 720 641 933-73.1O
6 720 641 933-91.1o
B
B
4
2
1
F
A
TB1
6 720 641 933-44.1O
45
Advertisement
Table of Contents
