Miele T 8033 C Operating And Installation Instructions page 26

Frequently asked questions
What if the "Filter/Vent" fault indicator is lit?
Possible fault
The lint filter is clogged.
The air supply in the room is
insufficient.
What if the program runs too long or stops?
Possible fault
The airflow is insufficient in the area of
the dryer.
The lint filters are clogged.
The laundry was not spun sufficiently in
the washer.
The dryer is overloaded.
Metal zippers interfere with the dryer's
moisture sensors.
The condenser is clogged with lint or
detergent residue.
The air vent below the door is blocked.
What if the laundry is not dry enough?
Possible fault
The load contained too many dissimilar items (size and fabric.)
What if water has collected around the drum opening?
Possible fault
This is condensed moisture from the laundry.
22
Solution
Clean the lint filters. See "Dryer care".
Open a window or door to increase
airflow.
Solution
Open a window or door to increase
airflow.
Clean the lint filters (see "Dryer care").
Select a higher spin speed in the wash
program.
Reduce the load size.
Select a timed program to avoid over
drying.
Clean the condenser periodically (see
"Dryer care").
Remove any blockages.