Operations; Basic Operation - Hertz HMR 15D Owner's Manual

9

OPERATIONS

9.1

Basic Operation

WARNING:
when the unit is turned on, starting and stopping the engine with its volume raised
to the maximum level may cause hearing damage. Make sure you adjust the volume in advance
Power On/Off
Note:
- Start the engine before using this unit.
- Be careful about using this unit for a long time without running the engine. If you drain the vessel battery,
you may not be able to start the engine and this can reduce the service life of the battery.
1. Start the engine.
Engine ON position
2. Press the
button to turn on the power in standby mode. Press and hold to turn off the power.
3. Press the SRC button to toggle source among Tuner, USB, BT Music, Aux In.
Adjusting the volume
Press VOL + / VOL- button to increase or decrease the volume.
The adjustable range of volume is 0 to 40.
WARNING:
while boating, keep the volume at a level at which external sounds can still be heard.
Please be aware of the volume levels in residential, family areas and local volume level ordinances.
System menu
- Press and hold SRC to enter system menu.
- Press SRC to move to the next option.
- Use the VOL +/- button to change the option value / setting.
1 Subwoofer Vol.: Press VOL + or VOL - to adjust the desired Subwoofer volume level range from -13 + 7
2 Subwoofer LP: Press VOL + or VOL - to change Subwoofer Lo-Pass filter: 80 -> 120 -> 160 Hz
3 Dimmer: Press VOL + or VOL - to select dimmer ON/OFF.
4 Bass: Press VOL + or VOL - to adjust the desired Bass level range from -7 to +7.
5 Treble: Press VOL + or VOL - to adjust the desired Treble level range from -7 to +7.
6 Balance: Press VOL + or VOL - to adjust the Balance between the right and left speakers from R10
(full right) to L10 (full left).
7 Fader: Press VOL + or VOL - to adjust the Fader between the front and rear speakers from R10
(full rear) to F10 (full front).
8 Beep: Press VOL + or VOL - to select beep on/off.
9 EQ (Preset Equalizer Setting): Press VOL + or VOL - to change EQ:
Hertz EQ -> Classic -> Pop.
10 LOUD: Press VOL + or VOL - to select loudness ON/OFF.
11 P-VOL: Press VOL + or VOL - to select the desired volume level upon turn on.
10